How to Install Pocket Rivet Fender Flares- A Step-by-Step Guide for a Flawless Fit

How to Install Pocket Rivet Fender Flares

Installing pocket rivet fender flares can be a challenging but rewarding DIY project for car enthusiasts. These flares not only enhance the appearance of your vehicle but also provide additional protection for the fender. In this article, we will guide you through the step-by-step process of installing pocket rivet fender flares on your car.

Step 1: Gather the Necessary Tools and Materials

Before you begin, make sure you have all the necessary tools and materials. You will need the following:

– Pocket rivet fender flares
– Rivet gun
– Rivet setter
– Drill and drill bits
– Screwdriver
– Socket set
– Safety glasses
– Gloves

Step 2: Clean the Fender

Start by cleaning the fender where the flares will be installed. Remove any dirt, rust, or old paint. This will ensure a better adhesion of the flares to the fender.

Step 3: Measure and Mark the Installation Points

Use a tape measure to determine the correct placement of the flares. Mark the installation points on the fender using a marker. It is crucial to measure accurately to ensure a proper fit.

Step 4: Drill Holes for the Rivets

Using the drill and drill bits, create holes at the marked points on the fender. Make sure the holes are slightly smaller than the diameter of the rivets to ensure a secure fit.

Step 5: Install the Rivets

Take the rivet setter and rivet gun, and install the rivets. Place the rivet setter on the fender and the rivet on top of it. Squeeze the trigger on the rivet gun to push the rivet through the fender and into the setter. The rivet setter will then expand the rivet, creating a pocket for the fender flare to sit in.

Step 6: Install the Fender Flares

Once the rivets are installed, place the fender flares onto the fender. Ensure that they are aligned with the rivet pockets. Secure the flares using the included screws or clips.

Step 7: Finishing Touches

After the fender flares are installed, inspect the work to ensure everything is secure. Clean up any excess rivet material or paint that may have been applied during the installation process.

Conclusion

Installing pocket rivet fender flares can be a fun and satisfying project for car enthusiasts. By following these steps, you can enhance the appearance of your vehicle and provide additional protection for the fender. Remember to take your time and measure accurately to ensure a proper fit. Happy installing!